Williams Sound DLT 100 2.0 Manual do Utilizador descarregar pdf (Página 13)

DLT 100 2.0 Digital Transceiver and DLR 60 2.0 Digital Receiver

· Use these buttons to select channels in simultaneous interpretation mode

QUICK GROUP CHANGE / SETUP BUTTONS

· Press and hold

and together for 3 seconds to enter or exit setup menu

· Press and hold

button for 3 seconds to enter quick group change mode. The GRP light will ash. Then use

or to change groups. To exit, push again or just wait until the unit times out.

· Use these buttons to select channels in simultaneous interpretation mode

MICROPHONE LEVEL ADJUSTMENT

· Hold the

button for two seconds to enter mic level adjustment. For level adjustment use or

VOLUME CONTROL / SELECT BUTTON

· Control / Volume

· Use to navigate selections in setup menu.

· Access and adjust tone control (0-53)

TALK BUTTON

· Press button momentarily once to activate the microphone. Press button once more to turn o the microphone

· Press and hold the button for approximately 2 seconds to mute other DLT 100 2.0 slave units. Only the CM and CS have this

function.

([TALK] LED will blink on all units when in mute mode).

Battery Charging – DLT 100 2.0

1. This Product uses an internal rechargeable Lithium Polymer battery.

2. Use the 30 Pin connector, located on the bottom of DLT 100 2.0 to charge the battery. Full charging time is approximately

5 hours. The Red LED ashes while charging. The Green LED will be on steady when the battery is charged.

3. Battery Maintenance - Charge the battery at room temperature.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Sem comentários

Williams Sound DLT 100 2.0 Manual do Utilizador Página 13