Williams Sound MOD 112 Guia de Instalação descarregar pdf (Página 6)

M

ounting Plate

Ballshaft

To

T

ransmitter

T

o Wall

Or

C

eiling

C

lamp Plate

T

ension Screw

Jaw

Fig. 4a: SB-3 Wall/Ceiling Mount

Williams Sound

®

Helping People Hear



7

Fig. 4b: Bracket 012 Ceiling Mounting

Fig. 4c: Bracket 012 Wall Mounting

The TX600 Two–Channel Infrared System

includes a kit for mounting the TX6 to a wall or

ceiling.

1. Use the 5/32" allen wrench to loosen the ten-

sion bolt in the clamp assembly enough to

release the ball. DO NOT unscrew the ten-

sion bolt completely. Using the mounting

plate as a template, mark the hole locations

on the mounting surface. Use fasteners

appropriate for the mounting surface (wood

screws, lag bolt, wall anchor) to attach the

mounting plate. Recommended fastener size

is 1/4".

2.

Attach the clamp plate to the rear of the

transmitter, using (2) 1/4 x 20 x 1/2" socket

head screws and 3/16 hex wrench provided.

Place the mounting plate in the position indi-

cated for ceiling or wall mounting.

3. Place the transmitter/clamp plate assembly

onto the the mounting plate ballshaft. Aim

the transmitter at the desired downward

angle and support it fully while using the

hex wrench to tighten the tension screw.

After initial installation, the ball will slowly

compress under pressure. Check the tension

screw after 15 minutes and re-tighten if nec

-

essary. DO NOT over-tighten.

If rotational adjustment is required, used a

7/16" open-end wrench to loosen the jam nut

on the ballshaft. Rotate the transmitter and

re-tighten the jam nut.

Figure 4: Mounting The TX6

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Comentários a estes Manuais

Sem comentários