Williams Sound WIR TX8 Guia de Instalação descarregar pdf (Página 9)

FIG. 7: WALL OR CEILING MOUNT

Figure 7a: Mounting the TX8 on

to a wall with the BKT 024.

Tip:

To keep the TX8 level,

rotate the tension screw (Fig. 6)

so it rests on top of the bracket.

Figure 7b: Mounting the TX8 on

to a ceiling with the BKT 024.

INSTALLATION PROCEDURE

The TX8 Infrared Emitter should not be installed outdoors, or where there is a lot of direct sunlight

indoors. Sunlight generates infrared interference. Certain types of high-efficiency lighting fixtures

can also generate interference at 95 kHz because they use high frequency modulation.

INSTALLATION STEP 1: MOUNTING THE TX8 TO A WALL OR CEILING

Step 1: Using the mounting plate (Figure 6) as a template, mark the hole locations on the mounting surface

where the TX8 will be installed. See Figure 7 below for optional mounting positions.

Step 2: Locate the top mounting hole in the rear of the TX8 emitter. Gently screw the male end of the swivel

head on to the emitter. Tighten the swivel head

tension screw

: turn clockwise until the connection is secure.

Step 3: Screw the male end of the shaft into the female end of the swivel head. An additional shaft can be

added to create more distance between the wall/ceiling and Emitter.

Step 4: Place the plate cover snugly over the mounting plate. This will hide the screws after installation.

Step 5: Screw the male end of the mounting plate into the female end of the shaft.

For suspended ceilings,

screw

the female end of the shaft into the male end of the

T-Bar clip

. The mounting bracket is now installed on to

the TX8 Emitter.

Step 6: Position the TX8 Emitter and BKT 024 so the mounting plate lines up with the marked holes on the

mounting surface. Fasten the mounting plate to the surface using screws and wall anchors.

Mounting

the TX8 to a Suspended Ceiling with Cross Tee:

Fasten the T-Bar clip on to the desired Cross Tee.

Step 7: Position the TX8 Emitter to the desired angle: Begin by gently turning the tension screw (Figure 6)

counter clockwise to release the swivel head. Adjust the TX8 to the desired angle. When the TX8 is in

the desired position, gently turn the tension screw clockwise until the swivel head is securely in place.

FIG. 6: BRACKET 024 MOUNTING

TX8 Emitter

Swivel Head

tension screw

Shaft

(optional)

Shaft Plate

Cover

Mounting

Plate

Mounting

Screws

(To Wall or Ceiling)

a b

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comentários a estes Manuais

Sem comentários

Williams Sound WIR TX8 Guia de Instalação Página 9

Comentários a estes Manuais

Manuais e produtos relacionados com Recetor Williams Sound WIR TX8